Specifications
Table Of Contents
- Notices
- Safety information
- About this guide
- M4A88T-M LE specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 CPU OverClocking
- 2.4.2 CPU Ratio
- 2.4.3 DRAM Frequency
- 2.4.4 CPU/NB Frequency
- 2.4.5 HT Link Speed
- 2.4.6 GPU OverClocking
- 2.4.7 DRAM Timing Configuration
- 2.4.8 DRAM Driving Configuration
- 2.4.9 CPU & NB Voltage Mode
- 2.4.10 CPU VDDA Voltage
- 2.4.11 DRAM Voltage
- 2.4.12 HT Voltage
- 2.4.13 NB Voltage
- 2.4.14 NB 1.8V Voltage
- 2.4.15 SB Voltage
- 2.4.16 CPU Load-Line Calibration
- 2.4.17 CPU/NB Load-Line Calibration
- 2.4.18 PCI/PCIe CLK Status
- 2.5 Advanced menu
- 2.6 Power menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
5. AMD
®
SB710 Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, or RAID 10 conguration through the onboard AMD
®
SB710
controller.
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.3.4 SATA Conguration for details.
• You must install Windows
®
XP Service Pack 2 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
®
XP SP2 or later version.
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.3.4 SATA Conguration for details.
ASUS M4A88T-M LE 1-25