Specifications
Table Of Contents
- Notices
- Safety information
- About this guide
- M4A88T-M LE specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 CPU OverClocking
- 2.4.2 CPU Ratio
- 2.4.3 DRAM Frequency
- 2.4.4 CPU/NB Frequency
- 2.4.5 HT Link Speed
- 2.4.6 GPU OverClocking
- 2.4.7 DRAM Timing Configuration
- 2.4.8 DRAM Driving Configuration
- 2.4.9 CPU & NB Voltage Mode
- 2.4.10 CPU VDDA Voltage
- 2.4.11 DRAM Voltage
- 2.4.12 HT Voltage
- 2.4.13 NB Voltage
- 2.4.14 NB 1.8V Voltage
- 2.4.15 SB Voltage
- 2.4.16 CPU Load-Line Calibration
- 2.4.17 CPU/NB Load-Line Calibration
- 2.4.18 PCI/PCIe CLK Status
- 2.5 Advanced menu
- 2.6 Power menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
4. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for Ultra DMA 133/100/66 signal cable. There are three
connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect
the blue connector to the motherboard’s IDE connector, then select one of the following
modes to congure your devices:
Drive jumper setting Mode of device(s) Cable connector
Single device Cable-Select or Master - Black
Two devices
Cable-Select
Master Black
Slave Gray
Master Master
Black or gray
Slave Slave
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select”, ensure that all other device jumpers have the
same setting.
Chapter 1: Product introduction1-24