User`s manual

3385 Scott Blvd.
Santa Clara, CA 95054-3115
T
el: +1/408.727.6600
Fax: [phone]
USBMobileHS ™ 2.32 - Release Notes
Updated: April 23, 2007
Table of Contents
1. Overview
2.
System Requirements
3.
Release Notes
3.1
What’s New
3.2
Known Issues
3.3
API
4.
Previous Releases
5.
Support
1. Overview
This Read Me file contains last-minute product information for the USBMobileHS™ software for Microsoft
Windows. For full instructions on using the USBMobileHS™ please see the User's Manual and other documents
provided with this product.
2. System Requirements
The following is a list of recommendations for the configuration of the host machine that runs the USBMobileHS™
application and that is connected to the USBMobileHS™ system. Please note that the application would operate
on systems with less memory and slower CPU rate than the recommended; however, for best results it is
recommended that the host machine meets or exceeds the suggested configuration.
2.1. Software
Operating System:
Microsoft Windows 2000 or Windows XP.
Required setup:
Microsoft Internet Explorer, version 5 or newer.
2.2. Hardware
Processor:
For optimum performance, use processors of Intel's PentiumIII/Pentium4 family, AMD’s Athlon/Duron family, or
other compatible processors with clock speed of 500mHz or higher (Processors of Intel’s Pentium II/Celeron
family or AMD’s K6 family with clock speed of 300mHz is a minimum).
Memory:
For the best performance, it is recommended to have at least 128MB of physical RAM.
Hard Disk:
Page 1 of 7USBMobileHS™ Release Notes
5/7/2007file://C:\Pro
g
ram Files\LeCro
y
\USBMobileHS\USBMobileHS
_
ReadMe.htm