User`s guide

28 XgOS User’s Guide • September 2014
■ 128 vNICs per card
■ Card-level High Availability (HA)
■ Access Control List (flow) policing
■ QoS on the vNICs configured on the card
■ MTU sizes from 1500 bytes to 9194 Kbytes
■ IPv4 TCP/UDP checksum offload. If you want TCP Offload configured on the
vNIC, you must set this value at vNIC creation time. You cannot edit a configured
vNIC to add the Offload feature later.
■ Untagged VLANs. Each vNIC can be assigned to a single untagged VLAN
(between 1 - 4000)
■ 8 traffic queues per vNIC
■ IGMP snooping. IGMP versions supported: v1, v2, v3 (partially supported)
■ Flow learning and statistics
■ 512 multicast groups
■ 802.1p, TOS, and DSCP mapping
To monitor 1-Port 10GbE I/O modules, use show ioport to inspect the state and
configuration information on the ports.
The following example displays a port on a card installed in slot 8:
The following example displays the card installed in slot 8:
show ioport 1/1
--------------------------------------
name 1/1
type nwEthernet10Port1GbCard
state up/up
descr
rate auto/1 Gbps
mtu 1500
avail-in-cir 1 Gbps
avail-out-cir 1 Gbps
mode access
flags -s
vnics 2
vlans none
--------------------------------------
1 record displayed
show iocard 1
--------------------------------------
slot 1
state up/up