User`s guide

384 XgOS User’s Guide • September 2014
The following example shows updating the HCA with firmware version 5.2.0.
6. Press Enter to exit the update script
Note – Whenever you run the script and burn firmware on one or more HCAs, shut
down the Windows server and then start it to bring HCAs up.
7. If HCAs have been updated, this cold boot is required bring them online with
the new firmware.
This completes the Windows host server upgrade. If you have more servers to
upgrade, complete that task now. If you have upgraded all servers, proceed to
“Upgrade OS on the Oracle Fabric Interconnect” on page 20-373 to upgrade your
second Oracle Fabric Interconnect OS.
Xsigo Dependency Service
The Xsigo dependency service, XgDependRoot, delays the services that depend
upon it for 60 seconds. Setting a dependency on this service allows the dependent
service to wait for the LUNs presented by the vHBA to be up and ready for use.
Setting the Dependency of Other Services Upon
XgDependRoot
For Windows shares that do not come up after the host is rebooted, run this
command after installing the Xsigo drivers.
Select Firmware to Burn> 1
Upgrading HCA firmware 5.1.400 to 5.2.0
This Will Flash HCA with Firmware file .\Image\fw-25218-5_2_0-
mhea28-xtc_a1-a2.bin
Please do not interrupt the burn process or reboot the machine...
Wait till burn completes ...
.................................................................
-----------------------------------------------------------------
The firmware on one or more of the HCAs has been upgraded.
It is recommended to reboot the machine in order for changes to
take effect.
-----------------------------------------------------------------
Press Enter key to continue