User`s guide

382 XgOS User’s Guide • September 2014

Note – The space following the equals sign (=) is mandatory.

This command causes the service to delay its start until LUNs are available across

the vHBA. For the details of the XgDependRoot service, see “Xsigo Dependency

Service” on page 384.

▼ Upgrading Windows HCA Firmware and

Option ROM

XgOS supports the following firmware levels:

■ InfiniHost Single Port HCA: 1.2.0

■ InfiniHost Dual Port HCA: 5.3.0

■ ConnectX and ConnectX-2: 2.7.0 and later

When the Xg_FWUpdate.vbs script runs, it first checks the current HCA Device ID

and firmware level and determines if an update is required.

To run the script, start a command prompt by following Start->Run....

2. Change directory to %programfiles%\Xsigo Systems\Support\

FirmwareUpdate.

This is the directory where the HCA firmware update script is located.

3. From the prompt, run the script by issuing the following command:

cd %programfiles%\Xsigo Systems\Support\FirmwareUpdate

cscript Xg_FWUpdate.vbs

Microsoft (R) Windows Script Host Version 5.6

reserved.

#################################################################

# Main Menu

#################################################################

Selected HCA Card Number: 0

HCA Device ID : mt25218_pciconf0

Image Type : failsafe

I.S. Version : 1

Device ID :

Chip Revision : a0