User`s guide

374 XgOS User’s Guide • September 2014
■ Using FTP, type:
If you upgrade using FTP, you will be prompted for a password.
Note – If you get the this error message during the upgrade, Installation
failed (Unable to unpack package file xsigo-3.9.2.xpf,issue the
system clear garbage command to remove any partial or failed installs.
When you issue the system upgrade command, the Fabric Interconnect begins the
upgrade. While the upgrade occurs, status messages are displayed, as shown in the
following example:
At this point, the Fabric Interconnect will restart, and you will be logged out. Wait
for a few minutes so that the Fabric Interconnect can complete its reboot, then log in.
When the Fabric Interconnect is rebooting, reboot ESX Server 1.
The Fabric Interconnect will take approximately 2 minutes to reboot, but
approximately 10 minutes for I/O cards, virtual resources, and all related services to
come back up and restore service.
system upgrade ftp://[e-mail]/upgrades/xgos-3.9.2.xpf
Copying...############################################################# [100%]
You have begun to upgrade the system software. Please be aware that this will
cause an I/O service interruption and the system may be rebooted.
The following software will be installed
1. XgOS Operating System software including SCP Base OS
2. XgOS Front-panel software
3. XgOS Common Chassis Management software on IOC
4. XgOS VNIC Manager and Agent software
5. XgOS VN10G and VN10x1G Manager and Agent software
6. XgOS VHBA and VHBA-2 Manager and Agent software
7. XgOS VN10G and VN10x1G Manager and Agent software with Eth/IB Interfaces
8. XgOS VHBA-3 Manager and Agent software
9. XgOS VHBA 2x 8G FC Manager and Agent software
10. HCA's Firmware and Option ROM
Are you sure you want to update the software (y/n)? y
Running verify scripts...
Running preunpack scripts...
Installing... ################################################# [100%]
Verifying... ################################################# [100%]
Running preinstall scripts...
The installer has determined that a cold restart of the Director is necessary
Installing package...
Running postinstall scripts...