User`s guide
Chapter 1 XgOS CLI Overview 13
■ Request an unbound vHBA to logout of the SAN fabric:
■ Display vHBA targets:
See “Virtual Host Bus Adapters (vHBAs)” on page 133 for more information.
I/O Card Commands
The I/O modules and ports are the termination points of vNICs and enable vNICs to
access network resources.
I/O Card Examples
■ Display all I/O cards in the chassis and their status:
■ Display the port status of all I/O ports in the chassis:
■ Change the MTU of an I/O port to support jumbo frames:
Note – You can only change the MTU of a port when no vNICs are assigned
■ Display the properties of a specific I/O port:
■ The show command shows all parameters for the specified I/O port.
set vhba vhba0.testserver remove-prescan
show vhba vhba2.testserver targets
show iocard
show ioport
set ethernet-port 8/4 –mtu=9194
show ioport 8/4