User`s guide

346 XgOS User’s Guide • September 2014
11. Upgrade the firmware by issuing the set physical-server command.
For example:
Note – The CLI will temporarily pause while the new firmware is being pushed to
the HCA. When the HCA is successfully put on to the HCA, XgOS returns to the
command prompt.
12. Upgrade the Option ROM by issuing the set physical-server command
and specifying the server’s LID.
For example:
Note – The CLI will temporarily pause while the new firmware is being pushed to
the HCA. When the HCA is successfully put on to the HCA, XgOS returns to the
command prompt.
13. Issue the show physical-server hca command, and verify that the new
firmware was installed.
If the Firmware version of Option ROM version field shows unknown, then
that software image is not present on the HCA.
14. When the correct image(s) are present, log in to the host and reboot it to load
the new images into memory.
set physical-server kingston upgrade-hca 7 firmware 3.0.0-fw.bin
Retrieve version information...
Upgrading HCA 0002c903000a9f7a firmware from 2.9.1000 to 3.0.0 will require a
manual server reboot in order to take effect. Do you wish to continue (y/n)?y
Upgrading HCA for 0002c903000a9f7a, current version is 2.9.1000...
set physical-server kingston upgrade-hca 7 optionrom
Upgrading HCA 2c903000459eb optionrom may interrupt I/O and will require a manual
server reboot in order to take effect. Do you wish to continue (y/n)?y
show physical-server kingston hca
Selected card:
Node GUID : '0002c903000a9f7a'
Board ID : 'MT_0A50120005'
Firmware version : '3.0.0'
Hardware version : 'A0'
Option ROM version : '2.8.7'