User`s guide

332 XgOS User’s Guide • September 2014
Power Down and Power Up
Because this command removes all configuration, you will typically only use this
command shortly before the Oracle Fabric Interconnect is powered off. You can
power off the Oracle Fabric Interconnect by removing both power cables. After you
restore factory defaults, the Oracle Fabric Interconnect can be manually restarted by
physically restoring facility power (reinserting power cables).
Syntax
Example
Software Information
Use the show software command to display software information.
Syntax
set system factory-default
set system factory-default
This is a very destructive operation. It will completely clear all state in the
Oracle Fabric Interconnect and shut down the system software. The system
willcontinue to pass traffic but will not be manageable. You will need to power
the Oracle Fabric Interconnect off by manually removing the power cords.
DO NOT CONFIRM THIS COMMAND IF YOU DON’T WANT TO LOSE EVERYTHING IN THE DIRECTOR.
Type 'confirm' to set the system to factory default state.
>confirm
show software