User`s guide

322 XgOS User’s Guide • September 2014
Network Time Protocol (NTP) Server
Syntax
Parameters
Login Methods
You can log into the CLI using the console or SSH. Telnet is not supported. Up to 20
concurrent CLI sessions can be established on the chassis (limited by the number of
instances available in the address object).
Console Login
The console port is the Serial 1 port (top) on the Management module. The Serial 2
port (bottom) is used for engineering debug purposes only.
Here are the default console serial port settings:
■ Baud rate: 115200 bps
set system ntp-server <address> [-prefer]
show system ntp-server
remove system ntp-server <address> [-confirm]
Parameters Description
<address> Specifies the IP address or domain name of the NTP server. For example,
192.168.99.100 or ntp.xyz.com
-prefer An optional qualifier that specifies whether the NTP server is the
preferred NTP in networks with multiple NTP servers.
-confirm An optional qualifier that controls whether a confirmation dialog is
displayed during any set or remove commands issued against the NTP
server.