User`s guide

Chapter 17 System Management 317

3. If you get the following error during the upgrade: Installation failed

(Unable to unpack package file xsigo-<build-x>.xpf where

<build

-x> is the system image, then issue the system clear garbage

command to remove any partial or failed installs.

4. When the Oracle Fabric Interconnect has completed its restart, issue the show

system version command to verify that the new software has been installed:

Clear Configuration

In general, a system clear config is not required before an upgrade. The only

reason you might want to clear your configuration is to completely wipe it out and

start over again. This command resets all values in the Oracle Fabric Interconnect’s

configuration database to the factory defaults. When you issue the system clear

config command, you are prompted for confirmation before the configuration is

cleared. When prompted, you must enter “confirm” to clear the configuration. Any

answer other than “confirm” aborts the system clear config command.

Example: Clear All Configuration and Upgrade

the System

Enter "help" for information on available commands.

show system version

Build 3.8.0-XGOS - (root) Sat May 22 06:54:53 UTC 2012

system clear config

This is a destructive operation. Your configuration will be cleared and the

system will be restarted. Please type 'confirm' to clear the configuration and

restart the system.

>confirm

system upgrade http://cairo.xsigo.com/upgrades/xsigo-V3.8.0.xpf

system cold-restart

Are you sure you want to restart the system (y/n)? y