User`s guide

220 XgOS User’s Guide • September 2014
Note – If you need to change an ACL rule, you do not need to remove the rule. You
can change the rule in real-time while the ACL is still attached to an I/O module by
issuing the set acl command to rewrite the rule
Syntax
Parameter Description
Example
Example: Denying Egress Traffic
This example creates an ACL that blocks any traffic heading in an egress direction
(server to network) where the destination IP address is equal to 10.2.16.5.
remove acl <acl-name>
remove acl *
remove acl <acl-name> rule <id>
Parameter Description
<acl-name> Removes a single ACL.
* Removes all ACLs.
rule <id> Removes a single rule from the ACL Rule Set
remove acl *
Remove all ACLs (y/n)?y