User`s guide

154 XgOS User’s Guide • September 2014
The most commonly used fibre-channel controls are rate, topology (topo), frame-
size, and execution-throttle. However, note that modified attributes do not take
effect until you reset the I/O card. See the example that follows.
Syntax
Note – Some port parameters (for example, topology mode) are displayed only
through the -detail option.
Parameter Description
Note – The set fc-port commands have been implemented with defaults that
are useful for most deployments. As a result, typically you do not need to change
the FC port parameters. However, the set fc-port commands do support setting
custom values. Oracle recommends that you use the default values for FC port
parameters, and change them only if absolutely required.
vhbas 1
-----------------------------------------------------------------
1 record displayed
set fc-port {*|<slot>/<port>} -descr=<text>
set fc-port {*|<slot>/<port>} -fc-link-down-timeout={<number>|default}
set fc-port {*|<slot>/<port>} -fc-target-port-down-timeout={<number>|default}
set fc-port {*|<slot/<port>>} -topology={f-port|l-port|n-port}
show fc-port {*|<slot>/<port>} [-detail]
show fc-port {*|<slot>} alarms [-detail]
show fc-port {*|<slot>} qos [-detail]
show fc-port {*|<slot>} stats [-detail]
show fc-port {*|<slot>} vhbas [-detail]