User`s guide

Chapter 8 Virtual Host Bus Adapters (vHBAs) 151
4. Configure this vHBA to rediscover (rescan state) the available LUN
information.
If there are any LUN changes, they will be reflected after this rescan operation:
5. Display any new target and LUN information:
Set FC Card Attributes
You can control the Fibre Channel card operational state through the set fc-card
command. Commands that affect card state also affect the FC ports on the cards, and
in turn, the vHBAs that are supported on the port.
Syntax
set vhba vhba888.titan rescan
show vhba vhba888.titan targets
set fc-card {*|<slot>} down [-descr=<text>]
set fc-card {*|<slot>} reset [-descr=<text>]
set fc-card {*|<slot>} up [-descr=<text>]
show fc-card {*|<slot>} dmesg
show fc-card {*|<slot>} errors
show fc-card {*|<slot>} ioport <port-number> [<wildcard>]
show fc-card {*|<slot>} ioports
show fc-card {*|<slot>} qos
show fc-card {*|<slot>} stats
show fc-card {*|<slot>} utilization
show fc-card {*|<slot>} vhbas
show fc-card {*|<slot>} warnings
watch fc-card {*|<slot>}
watch fc-cards