User`s guide

Chapter 8 Virtual Host Bus Adapters (vHBAs) 149
▼ Bind After prescan
The ideal scenario is to bind the prescan-discovery results to a host server. XgOS
supports binding the server profile with the phys-con after a prescan is complete, as
long as you follow the correct configuration order.
Follow these steps to perform a prescan then bind the server profile:
1. Create an unbound server profile:
2. Create a vHBA under this unbound server:
3. Set this vHBA to prescan state:
4. Display the targets:
From now on if there are any RSCN changes, the targets will also be updated
accordingly.
Note – At this point, you can also specify the target order by integrating persistent
mapping with prescan. See “Persistent Binding” on page 142. If you do, be sure to
issue remove-prescan before binding.
wwpn 50:01:39:70:00:00:F1:02
map
lun-mask
local-id 0
------------------------------------------------------------------------
1 record displayed
add server-profile III
add vhba vhbaiii.III 4/1
set vhba vhbaiii.III prescan
show vhba vhbaiii.III targets