User`s guide

148 XgOS User’s Guide • September 2014
▼ Enable prescan
To enable prescan for an unbound vHBA:
1. Create an unbound server profile, where the state is “unassigned”:
2. Create a vHBA under this unbound server:
At this point, show vhba <vhba-name>.<server-profile> will report the
state as “resourceUnavailable,” which is expected. The vHBA is not bound to
a server.
3. Set this vHBA to prescan state, which propagates target discovery to the FC
I/O card (sanFc2Port4GbLrCard) on the Oracle Fabric Interconnect:
4. Display the discovered targets and LUNs in the network environment. If you
add or remove a target on the array side, those changes will be reflected
accordingly on the Oracle Fabric Interconnect through RSCN:
add server-profile III
show server-profile III
-------------------------------------------------------------
name III
state up/
unassigned
...
add vhba vhbaiii.III 4/1
set vhba vhbaiii.III prescan
show vhba vhbaiii.III targets
vhba name wwnn wwpn lun-ids
------------------------------------------------------------------------
vhbaiii.III 2F:9F:00:06:2B:10:C3:BA 2F:9F:00:06:2B:10:C3:BA 3,2,1,0
vhbaiii.III 2F:BF:00:06:2B:10:C3:BA 2F:BF:00:06:2B:10:C3:BA 3,2,1,0
vhbaiii.III 2F:DF:00:06:2B:10:C3:BA 2F:DF:00:06:2B:10:C3:BA 3,2,1,0
vhbaiii.III 2F:FF:00:06:2B:10:C3:BA 2F:FF:00:06:2B:10:C3:BA 3,2,1,0
4 records displayed
show vhba vhbaiii.III
------------------------------------------------------------------------
name vhbaiii.III
state resourceUnavailable
fabric-state uninitialized
if 4/1
if-state down
wwnn 50:01:39:71:00:00:F1:02