User`s guide

Chapter 7 Virtual LANs (VLANs) 129
1. Configure the Ethernet port mode:
2. Add vNICs to the hosts:
3. On the hosts, configure the VLAN interfaces and assign an IP address to the
VLAN.
Example 3: Port Trunk Mode, VLAN-Unaware Host
Consider the example in the following figure.
In this example, traffic to and from the hosts does not contain any VLAN tags.
Because the port mode is trunk, VLAN tags are preserved between the Oracle Fabric
Interconnect and the external network.
The configuration procedure for this example would be as follows:
set ethernet-port 15/1 -mode=trunk -access-vlan=1
add vnic vn1.s1 15/1 -mode=trunk -access-vlan=1
add vnic vn1.s2 15/1 -mode=trunk -access-vlan=1