User`s guide

Chapter 6 Virtual Network Interface Cards (vNICs) 109
Parameter Description
▼ Set VLANs on a vNIC
Each vNIC comes with the default VLAN range (1-4095) already configured. To set a
specific VLAN range you must delete this default VLAN range, then add the specific
range.
1. Display the configured VLANs for the vNIC to which you want to add an
allowed VLAN range. You must use the -detail option to display the VLAN
range for the vNIC. For example:
Parameter Description
<vnic-name> Specifies the name of the vNIC to which you are adding a range of allowed
VLANs.
<VLAN-range> Specifies the range of allowed VLANs, which can be either a single VLAN, a
comma-separated list of VLANs, or a hyphenated range of VLANs.
-detail Specifies that additional, detailed output is displayed. To display the allowed
VLAN range, you must use this option.
show vnic vnic1.pluto -detail
-----------------------------------------------------------------
name vnic1.pluto
state up/up
mac-addr 00:13:97:03:71:5C
admin-ipaddr 0.0.0.0/32
oper-ipaddr 11.11.11.2/8
descr
if 7/10
if-state up
mcast-group
type hostManaged
mtu 9000
group
group-pref
ha-state
flags -------
vlans none
access-vlan 1
mode access
queue-map-type disabled
qos --
local-id 0
mirror