User`s guide

Chapter 6 Virtual Network Interface Cards (vNICs) 101
3. Display detailed vNIC information to verify that the mirror was created. Look
for the mirror field at the bottom of the display.
As an option, you can also display the following commands to determine that
mirror ports and mirror vNICs are configured and passing traffic:
If the counters are incrementing on the mirror port or vNIC(s), then the mirror is
configured and supporting traffic.
▼ Configure vNIC Mirroring for a vNIC
To configure an individual vNIC mirror on a port, use the set vnic commands. In
this example, assume the input vNIC “vn1.pubstest” will be mirrored to a vNIC
named “vn6.pubstest”. Both received and transmitted traffic will be mirrored to this
vNIC.
show vnic vn1.pubstest -detail
-----------------------------------------------------------------
name vn1.pubstest
state up/up
mac-addr 00:13:97:01:80:19
admin-ipaddr 0.0.0.0/32
oper-ipaddr 0.0.0.0/32
descr
if 4/1
if-state up
mcast-group
type dhcp
mtu 1500
group
group-pref
ha-state
flags ---
vlans none
access-vlan 1
mode access
queue-map-type disabled
qos i-
local-id 0
mirror 4/7(rxOnly)
-----------------------------------------------------------------
1 record displayed
watch ioports
watch vnics