User`s guide

Chapter 6 Virtual Network Interface Cards (vNICs) 95
Parameter Description
Set the MTU
1. Select the I/O port and set the new MTU value:
2. Confirm the new MTU setting:
Parameter Description
set ethernet-port <slot>/<port> Identifies the I/O module and port to be configured.
-mtu Sets the maximum transmission unit. The default MTU value is
1500. Accepted values are between 1500 and 9194. You cannot set
the MTU for a port if there are any vNICs are configured on that
port.
-flow-control Switches MAC flow control on or off for the port. You cannot change
this setting if there are any vNICs configured on the port.
show ethernet-port Displays information about the requested port configuration items:
alarms—Displays any alarms, such as the port having become
unavailable.
qos—Displays the quality-of-service policy set on the port, if any.
stats—Displays traffic statistics including MAC counters for the
port.
vnics—Displays information about the vNICs that terminate on
the port.
set ethernet-port 4/1 -mtu=9194
show ethernet-port 4/1
-----------------------------------------------------------------
name 4/1
type nwEthernet1GbPort
state up/up
descr
rate auto/1Gbps
mtu 9194
avail-in-cir 0Kbps
avail-out-cir 1Gbps
mode notApplicable
flags -s-
lag
access-vlan 1