User`s guide

92 XgOS User’s Guide • September 2014
Example: Show Ethernet Card Utilization
In the following example, the show ethernet-card utilization command is
issued against a 10-Port GE module in slot 14.
The command shows columns for different types of utilization for the card:
■ Total utilization, which is the sum of all the other columns.
■ Server utilization, the total amount of traffic that is transmitted to or received
from the server
■ Network utilization, the total amount of traffic that is passing through the card
transmitted to or received from the network.
■ Broadcast utilization, the total amount of broadcast traffic that is being processed
by the card.
Example: Watch an Ethernet Card
In the following example, the watch command is issued against a 10-Port GE
module in slot 14.
Gigabit Ethernet Port State
Use the show ethernet-port command to display information about the Gigabit
Ethernet module on which the vNICs are terminated.
show ethernet-card 14 utilization
name total-util server-util network-util bcast-util
-----------------------------------------------------------------
14 0 0 0 0
1 record displayed
watch ethernet-card 14
IOCard measured in bytes Wed Jul 13 09:20:37 PDT 2011
name type state rate util rate-stats util-stats
-----------------------------------------------------------------
14 nwEthernet10Port1GbCardEthIb up 0 0
1 record displayed
show ethernet-port <port>/<slot> alarms
show ethernet-port <port>/<slot> qos
show ethernet-port <port>/<slot> stats