User`s guide

Insyde -Confidential- Page
5 of 15
Enter the date in the format listed as an example: 12/16/2005 then hit <enter>
C. Mother Board Device Configuration
The Mother Board Device configuration contains the only sub menu system of the setup screens. The choices are
Drive Configuration: Allows the configuration of the storage devices.
LPC Card devices: Allows for the configuration of the serial and parallel ports on an LPC Card.
DDMA Channel Configuration: Allows for the configuration of the ISA DMA channels.
Video and Flat Panel Configuration: Allows for the configuration of flat panels and video memory.
GPIO Setting: Allows for the configuration of GPIO pins.
PCI Configuration: Allows for the configuration of PCI Interrupt Steering and SMBus setting.
Thermal Configuration: Reads the LM82 temperature.
D. Memory and Cache Optimizations
The Memory and Cache Optimizations screen should not be left in a shipping system. Misconfiguring the memory
can render the system unable to boot. If the system is configured incorrectly, it may be necessary to short CMOS to
get the system to boot.
Cache Enable: Allows the configuration of the Cache of the system to be either Enabled or Disabled
Cache Mode: Allows the selection of the Cache mode to be either Write-Back or Write-Through
L2 Cache Enable: Allows L2 Cache of the system to be either Enabled or Disabled
Cache Allocate: Allows Cache Allocate to be either Enabled or Disabled
DIMM 0 or 1:
Memory Optimization DIMM 0 or 1: Allows the memory to be configured by Automatically or
Manually. If Auto is selected, DIMM Page Size, DIMM Size, Number of Devices, DIMM Module Banks,
and DIMM Component Banks will be grayed out.
DIMM 0 or 1 Page Size: Allows selections of Not Installed, 1, 2, 4, 8, 16 KB
DIMM 0 or 1 Size: Allows for the configuration of the Memory size to be 8M, 16M, 32M, 64M
128M, 256M, 512M
Number of Devices: Allows selections of 0, 2, 4, 8, 16, 32
DIMM 0 or 1 Module Banks: Allows for the configuration of the number of module banks.
Options are 1 or 2
DIMM 0 or 1 Component Banks: Allows for the configuration of the component banks Options
2 or 4