User`s guide

Insyde -Confidential- Page
13 of 15
HSYNC Polarity: Selects the active polarity of the HSYNC signal to the panel. The options are
Active Low or Active High.
VSYNC Polarity: Selects the active polarity of the VSYNC signal to the panel. The options are
Active Low or Active High.
LP Active Period: Selects the active period of the LDE/MOD (LP) signal. The options are Free
Running and Active Only.
SHFCLK Active Period: Selects the active period of the SHFCHK signal. The options are Free
Running and Active Only
Software Backlight Control
Backlight Enable: Selects if the software controlled flat panel backlighting is Enabled or Disabled.
Initial Brightness: Selects the initial backlight value for the panel. The options are Last Value, 0% (Off),
10%, 20%, 30%, 40%,50%, 60%, 70%, 80%, 90%, 100% (Full On)
TV Output Configuration This will be grayed out unless the Output display menu choice is set to TV output.
TV Encoder: This enables the TV encoder that is attached to the system to be specified. The choices
are AUTO, ADV7171, SAA7127, ADV7301, and FS454. (If Auto is selected, then TV Standard and
TV Resolution will be grayed out. TV Resolution may only be set for the FS454.)
TV Standard: Allows the TV display standard to be selected. The choices are NTSC, PAL, and
HDTV.
TV Resolution: Allows the setting of the television resolution. The choices are Low, Medium, and
High.
C-G GPIO Setting
The following menu system allows for configuration of some GPIO pins.
GPIO pins setting
GPIO6: This pin can be set to Available or used as the MFGPT0_RS pin.
GPIO25: This pin can be set to Available or used as the LOW_BAT# pin.