User`s guide

Insyde -Confidential- Page
10 of 15
Motherboard Device Configuration
C-A Drive Configuration
The drive configuration screen determines the setup for the Hard drives, Floppy, CD-ROM, and Flash
configurations.
Hard Drive Configuration
IDE BIOS Support: Allows the configuration of the IDE channel. The options are Enabled or Disabled.
80-Conductor Cable Sense: Selects the GPIO that is connected to the IDE –PDIAG sense. The
options are None (Disabled), Force 40 Conductor Cable, Force 80 Conductor Cable, and GPIO 05.
DMA/UDMA BIOS Support: This enables DMA/UDMA timings. The options are Enabled and
Disabled.
Force mode for Drive 1 or 2: This enables the transfer mode. The options are Auto, PIO 0-4,
MDMA 0-2, and UDMA 0-5.
Floppy Configuration
Floppy BIOS Support: Allows the Floppy to be either Enabled or Disabled.
CD-ROM Boot Configuration
CD-ROM Boot BIOS Support: Allows the CD-ROM to be either Enabled or Disabled.
Flash Configuration: Allows the use of a flash device over the IDE.
Flash Interface: The flash device may be either Enabled or Disabled.
Chip Select 0- 3
Size: Allows the Memory size / I/O size configuration of the flash chips to be Disabled,
8K/16B, 16K/32B, 128K/64B, 512K/128B, 4M/256B, 8M/256B, or 256M/256B.
Base: Allows the configuration of the base address. The options are PCI default, D2000,
D4000, or D6000.
Type: Allows the selection of the type of flash memory. The options are Nor Mem, or
NAND I/O.