Installation guide

IEM-LX-800 ETX CPU Module
IDE DMA transfer access [Enabled].....................................................................80
IDE HDD Block Mode [Enabled] ...........................................................................81
ATA 66/100 Support [Enabled] .............................................................................81
Onboard FDC Controller [Disabled].....................................................................81
Onboard Serial Port 1 [3F8/IRQ4].........................................................................81
Onboard Serial Port 2 [3F8/IRQ4].........................................................................82
UART Mode Select [Normal].................................................................................82
RxD, TxD Active [Hi,Lo].........................................................................................82
IR Transmission Delay [Enabled].........................................................................83
UR2 Duplex Mode [Half] ........................................................................................83
Use IR Pins [IR-Rx2Tx2]........................................................................................83
Onboard Parallel Port [378/IRQ7].........................................................................83
Parallel Port Mode [SPP].......................................................................................84
EPP Mode Select [EPP1.7]....................................................................................84
ECP Mode Use DMA [3].........................................................................................85
CIR Port Address...................................................................................................85
xCIR Port IRQ ....................................................................................................85
ACPI Function [Enabled].......................................................................................86
ACPI Suspend Type [S1(POS)].............................................................................86
Power Management [ACPI]...................................................................................86
Standby Mode [Disabled]......................................................................................87
Suspend Mode [Disabled].....................................................................................87
Soft-Off by PWR-BTTN [Instant-Off] ....................................................................88
Power-On by Alarm [Disabled].............................................................................88
PNP OS Installed [No] ...........................................................................................89
Reset Configuration Data [Disabled]...................................................................90
Resources Controlled By [Auto (ESCD)].............................................................90
x IRQ Resources [Press Enter].............................................................................90
x IRQ Resources [Press Enter].............................................................................92
Reserved Memory Base ........................................................................................92
Reserved Memory Length.....................................................................................93
Page 118