User`s manual

BIOS Setup

IDE HDD Block Mode

Enabled The IDE HDD uses the block mode. The system BIOS

will check the hard disk drive for the maximum block

size the system can transfer. The block size will depend

on the type of hard disk drive.

Disabled The IDE HDD uses the standard mode.

IDE DMA Transfer Access

Enabled The IDE HDD uses the block mode. The system BIOS

will check the hard disk drive for the maximum block

size the system can transfer. The block size will depend

on the type of hard disk drive.

Disabled The IDE HDD uses the standard mode.

OnChip IDE Channel 0 and OnChip IDE Channel 1

These fields allow you to enable or disable the primary and

secondary IDE controller. The default is Enabled. Select Disabled if

you want to add a different hard drive controller.

OnChip IDE Device

The settings on the screen are for reference only. Your version may not be

identical to this one.

IDE HDD Block Mode

IDE DMA Transfer

Onchip IDE Channel0

Onchip IDE Channel 1

Primary Master PIO

Primary Slave PIO

Secondary Master PIO

Secondary Slave PIO

Primary Master UDMA

Primary Slave UDMA

Secondary Master UDMA

Secondary Slave UDMA

Phoenix - AwardBIOS CMOS Setup Utility

OnChip IDE Device

Item Help

Menu Level

↑↓→←: Move Enter: Select F1: General Help+/-/PU/PD: Value F10: Save ESC: Exit

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Enabled

Auto