User's Manual

❺Navigate to "add" and select the channel to add
the camera.
❻Press the button and the Pairing indicator will
begin to rapidly flash. This rapid flashing indicates
that the device is waiting to be paired with the
camera.
❼ Now the camera is paired with the handset.
❽To view the camera picture, please back out of
the menu and hold the key for two seconds to
engage the alternate function for the handset keys.
❾Then press the camera switch/scan key to the
bottom right of the handset face to change the
camera channels.
The indicator will remain unlit when viewing the
camera during normal operation of the handset. This
indicated the camera channel is properly paired. The
indicator will slowly flash if signal is lost when camera
and handset are paired. Please move closer to the
camera to reconnect. If the camera and handset do
not automatically reconnect, check the camera to
ensure it is properly powered. The camera may need
to be repaired to the handset in some cases.
Place the camera in the desired mounting area, then
move around the home with the handset. If issues
with signal loss occur, then reposition and test again.
❶

Begin by drilling a pilot hole in the drywall of
your home with a 3/16 inch (4.7mm) drill bit.
❷Insert the drywall anchor into the pilot hole. Tap
4.5 Wall Mounting The Camera Unit
27 28
the anchor with a hammer to set it properly to seat
the anchor.
❸Tighten the screw into the drywall anchor until
the screw is sticking out of the wall about 1/8 of an
inch. If needed, reverse the screw slightly so the
camera fits easier on the screw.
❹Locate the hole on the bottom of the camera
that is large enough for the screw head to fit. Note
the hole tapers to a smaller notch.
❺Slide the camera over the screw and then down
into the notched section of the hole. The camera
should be snug against the wall after it's been slid
down onto the screw. If the camera is not snug, then
remove the camera from the screw, tighten the
screw further into the wall, and replace the camera
on the screw.
❻Plug the power adapter into the camera. Please
do not have the power wire any closer than 3 feet
from your child's crib or play area.
OPTIONAL:
Mount the wire to the wall by using cable raceway
or clips. These are good solutions to ensure the
cable is kept out of reach. Please note these are not
included and are optional to the installation.
Connect the small plug located at the end of the
power adaptor to the handset and the other end of
the power adapter to the wall.
With the handset now plugged into the wall, notice
that the battery icon on the upper right-hand corner
of the screen will show a charging animation. This
indicates the handset is charging. When the handset
is completely charged, the animation will show the
battery being full.
4.6 Charging
Note
› If the camera did not pair, please repeat the steps listed
above.
› There will be 15 seconds of allotted time for the handset
and camera to establish the connection. If this time
expires, the pairing process must be started over again.
Note
Before installing the camera on thewall, it is important to
test the reception ofthe handset to the camera.