User manual

Chapter 2 Installation
13
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
Transducer Outline Drawings
The appropriate outline drawing is included with the transducer when shipped. The outline
drawings of the HTT-20-(x) and HTT-400-180 transducers are also shown below.
HTT-20-(x): Anodized/Painted Aluminum Body, 1070 Carbon Steel Shaft, NEMA 4
(x) = 100, 180, 1,000, or 1,800
0.500"
(12.70)
(30.010)
1.1815"
1.1807"
(29.990)
0.70"
(17.8)
max.
Total Clearance of 5.5"
(140)
needed
for removal of mating connector.
MS3102E20-27P Connector
0.500"
(12.70)
1/4 - 20 UNC-2B
0.50"
(12.7)
min. depth.
Four places
0.375"
(9.53)
0.150"
(3.81)
(15.867)
0.6247"
0.6237"
(15.842)
3.000"
(76.20)
2.000"
(50.80)
1.000"
(25.40)
1.000"
(25.40)
1.25"
(31.8)
4.00"
(101.60)
1.175"
(29.85)
( ) = Dimensions in milimeters
2.000"
(50.80)
4.375"
(111.13)
Painted Body
Anodized Flange
Figure 2.2 HTT-20-(x) Outline Drawing
HTT-400-180: Anodized Aluminum Body, 1070 Carbon Steel Shaft, NEMA 4
0.6247"
0.6237"
(15.842)
1.250"
(31.75)
4.27"
(108.5)
1.60" Sq.
6.41"
(162)
1" NPT Thread
4.00"
(101.6)
Dia. ± 0.01"
(0.3)
#10-32 UNF-2B. 0.50"
(12.7)
min. depth.
Four places, 90° apart on 2.50"
(63.5)
B.C.
2.000"
(50.80)
1.000"
(25.40)
2.000"
(50.80)
1.000"
(25.40)
1/4-20 UNC-2B 0.50"
(12.7)
min. depth.
Four places.
#8-32 Screws, 4 places. Remove to access resolver connections.
When re-installing plate, make sure the gasket is seated correctly and not pinched.
(15.867)
(40.6)
( ) = Dimensions in millimeters
0.55"
(14.0)
0.1885
(4.79)
0.1895
(4.81)
X
DEEP X 1.0
(25.4)
KEY
0.187
(4.75)
0.188
(4.78)
SQ. X 1.0
(25.4)
0.106
(2.69)
0.108
(2.74)
KEYWAY
Figure 2.3 HTT-400-180 Outline Drawing