Specifications

405GP – Power PC 405GP Embedded Processor
56 AMCC
Revision 2.01 – January 6, 2005
Data Sheet
Revision Log
PCI Divider from PLB
2, 3
D18/A20
GPIO1[TS1E]
C20/C19
GPIO2[TS2E]
Divide by 1 0 0
Divide by 2 0 1
Divide by 3 1 0
Divide by 4 1 1
External Bus Divider from PLB
2
K25/K20
EMCTxErr
K23/J21
EMCTxEn
Divide by 2 0 0
Divide by 3 0 1
Divide by 4 1 0
Divide by 5 1 1
ROM Width
AC2/N3
UART1_Tx
AD2/N7
UART1_RTS
/
UART1_DTR
8-bit ROM 0 0
16-bit ROM 0 1
32-bit ROM 1 0
Reserved 1 1
ROM Location U2/P4
HoldAck
PPC405GP Peripheral Attach 0
PPC405GP PCI Attach 1
PCI Asynchronous Mode Enable Y3/U4
ExtAck
Synchronous PCI Mode 0
Asynchronous Mode 1
PCI Arbiter Enable
3
AF18/AB18
GPIO4[TS2O]
Internal Arbiter Disabled 0
Internal Arbiter Enabled 1
Note:
1. The tune bits adjust parameters that control PLL jitter. The recommended values minimize jitter for the PLL implemented in the
PPC405GP. These bits are shown for information only; and do not require modification except in special clocking circumstances such as
spread spectrum clocking. For details on the use of Spread Spectrum Clock Generators (SSCGs) with the PPC405GP, visit the technical
documents area of the AMCC PowerPC web site.
2. Not all combinations of dividers produce valid operating configurations. Frequencies must be within the limits specified in “Clocking
Specifications” on page 47. Further requirements are detailed in the Clocking chapter of the PowerPC 405GP Embedded Processor
User’s Manual.
3. Additional consideration must be given to pins that normally function as Trace signals. Improved design margin can be gained by using
three-state buffers instead of strapping resistors, and minimizing trace lengths and stubs.
Date Contents of Modification
02/12/2003 Timing diagram update
04/14/2003 Update legal statements regarding document status.
06/19/2003 Add 133 MHz part numbers.
12/02/2004 Update to AMCC format.
01/06/2005
Add lead-free PNs.
Correct typographical error in 27mm package drawing.
PPC405GP Strapping Pin Assignments (Part 2 of 2)
Function Option Ball Strapping