User guide
Table Of Contents
- Title Page
- Table of Contents
- About this User Guide
- Introducing the 3ware® SATA RAID Controller
- Getting Started with Your 3ware RAID Controller
- First-Time RAID Configuration Using 3BM
- Driver Installation
- Driver Installation Under Windows
- Driver Installation Under Linux
- Obtaining 3ware Linux Drivers
- Driver Installation Under Red Hat Linux or Fedora Core 5
- Materials required
- Creating a Red Hat Linux Driver Diskette
- Installing the 3ware Kernel Driver Module while Installing Red Hat Linux on a New Unit
- Installing the 3ware Kernel Driver Module on a Red Hat or Fedora Core Linux System that Boots From a Different Device
- About Variables In the Kernel Driver Module Installation Instructions
- Driver Installation Under SuSE Linux
- Compiling a 3ware Driver for Linux
- Driver Installation Under FreeBSD
- 3ware BIOS Manager 2 (3BM 2) Introduction
- 3DM 2 (3ware Disk Manager) Introduction
- Configuring Your Controller
- Configuring Units
- Configuring a New Unit
- Creating a Hot Spare
- Naming a Unit
- Setting Unit Policies
- Changing An Existing Configuration by Migrating
- Deleting a Unit
- Removing a Unit
- Moving a Unit from One Controller to Another
- Adding a Drive
- Removing a Drive
- Rescanning the Controller
- Maintaining Units
- Checking Unit and Drive Status through 3DM
- About Degraded Units
- About Inoperable Units
- Alarms, Errors, and Other Events
- Background Tasks
- Scheduling Background Tasks
- Locating a Drive by Blinking Its LED
- Maintaining Your Controller
- Determining the Current Version of Your 3ware Driver
- Updating the Firmware and Driver
- Downloading the Driver and Firmware
- Updating the Firmware Through 3DM 2
- Updating the 3ware Driver and Firmware Under Windows
- Using the Update Utility With Multiple Controllers
- Updating the 3ware Driver Under Windows XP
- Updating the 3ware Driver Under Red Hat or Fedora Core
- Updating the 3ware Driver Under SuSE
- Updating the 3ware Driver Under FreeBSD
- Updating the Firmware Under Linux and FreeBSD
- Viewing Battery Information
- Testing Battery Capacity
- 3DM 2 Reference
- Troubleshooting
- Appendices
- Index
Checking the Motherboard Boot Sequence
www.3ware.com 29
Checking the Motherboard Boot Sequence
Using your computer’s Setup utility, ensure that it shows the appropriate boot
device.
After installing the 3ware 9000 controller in your system, go into the BIOS
for your computer system to check and change the boot order. This is
necessary because most systems automatically change the boot order when
they detect a newly installed controller and device. Refer to the
documentation for your system for information about starting the system
BIOS.
• If the OS is already installed on a unit connected to the system, be
sure that device precedes the 3ware RAID controller in the boot sequence.
If you have other disks installed on the motherboard, the 3ware RAID
controller should precede them in boot order.
• If you will install your OS on a disk or unit attached to the 3ware
RAID controller, specify the controller as the boot device. (Note that if
you configured more than one unit, the drive(s) specified as Unit 0 will be
treated as the boot disk.)
What Next?
The final steps in setting up your RAID units are to load the 3ware driver and
make the units available to your operating system. For details, turn to
Chapter 4, “Driver Installation.”
After installing the driver, in order to maintain your RAID units, you may also
want to install 3ware’s browser-based Disk Management tool, 3DM 2, or the
3ware Command Line Interface (CLI). For more information, see
Appendix B, “Software Installation” on page 271.