Computer Accessories User Manual
Table Of Contents
- Title Page
- Table of Contents
- About this User Guide
- Getting Started with Your 3ware RAID Controller
- Introducing the 3ware® 9590SE-4ME RAID Controller
- 3DM 2 (3ware Disk Manager) Introduction
- Configuring Your Controller
- Configuring Units
- Maintaining Units
- Checking Unit and Drive Status
- About Degraded Units
- About Inoperable Units
- Alarms, Errors, and Other Events
- Background Tasks
- Scheduling Background Tasks
- Locating a Drive by Blinking Its LED
- Maintaining Your Controller
- 3DM 2 Reference
- Troubleshooting
- Appendices
- Index
Chapter 4. Configuring Your Controller
30 3ware Serial ATA RAID Controller User Guide for the Power Mac G5
Viewing Controller Policies
You can view the current state of controller policies in 3DM, in the Other
Controller Settings
section at the bottom of the Controller Settings page (See
Figure 11.) Only the Auto Rebuild, Auto-Carving, and Carve Size policies
can be changed on this page. The other policies do not apply to the Macintosh.
For a summary of the initial default settings, see Table 2, “Default Settings for
Policies and Background Tasks,” on page 3.
To view controller policies in 3DM
• Choose
Management > Controller Settings from the menu bar.
Figure 11. 3DM Controller Settings Page
Note: Throughout this documentation, the term current controller is used to refer to
the controller currently selected in this drop-down list.