Computer Accessories User Manual
Table Of Contents
- Title Page
- Table of Contents
- About this User Guide
- Getting Started with Your 3ware RAID Controller
- Introducing the 3ware® 9590SE-4ME RAID Controller
- 3DM 2 (3ware Disk Manager) Introduction
- Configuring Your Controller
- Configuring Units
- Maintaining Units
- Checking Unit and Drive Status
- About Degraded Units
- About Inoperable Units
- Alarms, Errors, and Other Events
- Background Tasks
- Scheduling Background Tasks
- Locating a Drive by Blinking Its LED
- Maintaining Your Controller
- 3DM 2 Reference
- Troubleshooting
- Appendices
- Index
Appendix B. Driver and Software Installation
146 3ware Serial ATA RAID Controller User Guide for the Power Mac G5
10 If you want the Installation Wizard to launch 3DM 2 after you finish the
wizard, check the
Connect to 3DM2 box. This allows you to log into
3DM and configure a RAID unit right away.
If you do not want to launch 3DM 2 at this time, leave the box unchecked.
When you are ready, click
Next to continue.
Figure 53. Final Installation Screen
11 On the summary screen, review the installation that is about to occur.
If you want to make changes, use the
Back button to move back through
the screens.
When you are ready, click
Install to continue.
Figure 54. Installation Summary Screen