User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
8
AXIS Media Control - Installing AMC and Decoders
6. Finally, click Close to complete the installation.
Remove AAC Decoder
To remove the decoder:
1. Open the C:\Program Files\Axis Communications\Components folder.
2. Right-click the file AxAacDec.dll and select Delete.
Install MPEG-4 Decoder
On the Live View page of your Axis camera, you can select to view live video over your network or over the Internet, using
either Motion JPEG, MPEG-4 or H.264. If you select MPEG-4, you will be prompted to install an MPEG-4 decoder.
Note: A system administrator may prevent users from installing and updating the MPEG-4 decoder. If you have a problem installing the
MPEG-4 decoder, please see you system administrator.
1. To start the installation, select the Click here to install or upgrade the MPEG-4 Decoder link in the Live View page
as shown in the figure below.