User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
6
AXIS Media Control - Installing AMC and Decoders
Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
1. If you need to remove AMC from your computer, click Start > Control Panel > Programs > Uninstall a Program
to remove the program.
2. Select AXIS Media Control Embedded. Do not delete the AXIS Media Control program since other Axis products
may use it.
Install AAC Decoder
If you want to hear or transmit audio from your Axis camera over your network or over the Internet, and your hardware
supports AAC audio, you will need to install an AAC decoder.
1. To start the installation, select the Click here to install or upgrade the AAC Decoder link in the Live View page as
shown in the figure below.
2. Read through the AAC license agreement that appears, and if you agree to the conditions, select I accept the
License agreement and click OK.