User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
16
AXIS Media Control - AMC Control Panel
AMC Control Panel
The AMC Control Panel is used to configure AMC. The figure below, the General tab, shows the different parts of AMC that
can be configured such as Audio, Network and PTZ. The sections below describe each of these AMC tabs and how to configure
AMC.
Open the AMC Control Panel by clicking Start > Settings > Control Panel > Axis Media Control or by right-clicking in the
video window on the Live View page and selecting Settings. Depending on which camera you are using, you will have either
some or all of the following tabs shown in the figure.
Note: If you are using a simpler Axis camera, not all of the tabs shown below will be visible. If you then log into a camera with greater
functionality, the necessary software will also be installed for use with that camera. If you later go back to the simpler camera, while not
usable, the additional tabs will still be visible
.