User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
15
AXIS Media Control - Toolbar Controls in Live View
Pan/Tilt/Zoom Controls
The default setting for PTZ is the Center Mode. When in Center Mode, click on any part of the image other
than its exact center and the camera will move so that the point you clicked on becomes the new center of
the image.
If you select Emulate Joystick Mode, the camera moves in the direction of the mouse pointer. If you click and
hold down on the left mouse button, and then point to the lower left hand corner of the image, the camera
continues to move left and down until you release the mouse button.
Area Zoom allows you to zoom in on a specific area of the video stream. Put the pointer where you want the center of
the area you want to zoom in on, and then drag the pointer out as far as the size of the area you want to zoom in on.
Note that AMC is dependent on the camera's zoom calibration.