User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
11
AXIS Media Control - Installing AMC and Decoders
Install H.264 Decoder
On the Live View page of your Axis camera, you can select to view live video over your network or over the Internet, using
either Motion JPEG, MPEG-4 or H.264. If you select H.264, you will be prompted to install an H.264 decoder.
Note: A system administrator may prevent users from installing and updating the H.264 decoder. If you have a problem installing the MPEG-4
decoder, please see you system administrator.
1. To start the installation, select the Click here to install or upgrade the H.264 Decoder link in the Live View page
as shown in the figure below.
2. Read through the H.264 license agreement that appears, and if you agree to the conditions, select I accept the
License agreement and click OK.