Operation Manual

25
User’s manual
EN
TROUBLESHOOTING GUIDE
TROUBLESHOOTING
The information below is designed to help identify and correct any faults and/or malfunctions which may occur during operation.
Some failures can be resolved by the user; others require specic technical skills or special abilities and therefore must only be
resolved by qualied personnel with certied experience gained in the specic eld of intervention.
Problem Cause Remedies
The robot is very noisy.
Cutting blade damaged.
Replace the blade with a new one (see “Blade
Replacement”).
Cutting blade fouled (tapes, ropes,
plastic fragments, etc.).
Stop the robot safely (see “Robot safety stop”).
Warning – Caution
Use protective gloves to avoid the risk of
injury.
Remove the debris from the blade.
The robot was started too close to
obstacles (less than 1 m. (40 ") away)
or in the presence of unexpected
obstacles (fallen branches, forgotten
objects, etc.).
Stop the robot safely (see “Robot safety stop”).
Remove the obstacles and restart the robot.
Electric motor failure.
Have the motor repaired or replaced by the
nearest authorised service centre.
Too high grass.
Increase the cutting height (see “Cutting height
adjustment”).
Carry out a preliminary cutting of the area with a
normal lawnmower.
The work area is not
completely mowed.
Not enough work hours. Start the robot every day.
Cutting blade fouled with deposits and/
or residuals.
Stop the robot safely (see “Robot safety stop”).
Warning – Caution
Use protective gloves to avoid the risk of
injury.
Clean the cutting blade.
Cutting blade worn.
Replace the blade with original spare parts (see
“Blade Replacement”).
Work area is too big compared to the
actual capacity of the robot.
Adjust the work area (see “Technical
Specications”).
The batteries are about to end their life
cycle.
Replace the batteries with original spare parts.
The batteries do not recharge
completely.
Clean and remove any oxidizations from the
contact points of the batteries (see “Robot
cleaning”). Recharge the batteries for at least 4
hours.