Operation Manual

19
User’s manual
EN
OPERATION WITH DELAY OPERATION
With the robot in PAUSE mode,
press the “ON/OFF”
button for each hour of delay
The Robot goes into STAND-BY
waiting for the preset departure time
Wait
Press “PLAY/PAUSE”
e.g. 4 times
=
4 hours
4 beeps
=
4 hours
STARTING THE ROBOT WITH THE SENSORS TURNED OFF
In certain lawn conditions, the robot can be started with the lawn and curb drop-off sensors deactivated, which means the robot
can be started when lawn conditions are such that correct functions are not guaranteed, for example with very short or patchy
grass.
This mode requires very special attention from the user, and the dealer should be consulted before attempting to operate in this
mode.
When the robot is on Pause, these modes can be activated following this procedure:
Grass Sensor Off – Curb drop-off sensor On:
Press the “PLAY/PAUSE” button and keep it pressed for 4 seconds
until 2 consecutive beeps are heard and the PAUSE led ashes
twice. This mode must only be used on models with the curb drop-
off sensor installed, and it allows working with just the 4 curb drop-
off sensors. This mode is recommended in gardens where the
lawn is lower than the sensors but still very uniform.
GULF
With the curb drop-off sensor installed,
minimum width 10 cm / 4.0
"
GRASS SENSOR OFF - CURB DROP-OFF SENSOR ON
Keep the “PLAY/PAUSE” button pressed
for 4 seconds.
Release the button
Wait for
2 beeps 2 flashes
+
4 sec.