Manualshelf

Operation Manual

ManualsBrandsAmbrogio ManualsToolsL50
11121314151617181920
18
User’s manual
EN
RECHARGING ROBOT
A. HIGH BATTERY:
(GREEN LED STEADY ON)
full battery level.
PLAY
OFF
ON
PAUSE
STOP
H
I
G
H
B
A
T
T
E
R
Y
L
O
W
B
A
T
T
E
R
Y
(A)
(B)
(C)
(D)
1
(GREEN LED 1 FLASH)
medium battery level.
B. LOW BATTERY:
(RED LED STEADY ON)
low battery level.
C. ON/OFF:
(GREEN LED STEADY ON)
robot in operation.
START-UP
1. Check that the grassy surface of the lawn to mow is at a height which is compatible with the proper functioning of the robot
(see technical specications).
2. Adjust the desired cutting height (see cutting height adjustment).
3. Check that the work area is correctly delimited and that there are no impediments to the correct functioning of the robot as
indicated in the section “Preparation and dening the boundaries of the work areas” and following sections.
4. Disconnect the robot from the recharging area.
5. Position the robot inside the grassy surface in an area where the grass is at least 1 metre (40.00 ") from any obstacle.
6. Press the “OFF/ON” key and wait a few seconds for the robot to turn on completely.
7. Press “PLAY/PAUSE” key to start the robot.
Once the robot has stopped due to the reasons described in the chapter “Robot Stop”, activate the safety stop and reposition the
robot inside the power supply unit for recharging.
Important
For a better cutting performance and correct functioning of the recognition sensor, do not start the robot in
case of rain or in very humid conditions. The best results are obtained in the middle of the day.
OPERATION WITH DELAYED START
If necessary, the robot can be delayed to start by up to 24 hours.
Press the “OFF/ON” button. After a few seconds the robot switches completely on. Press briey the “OFF/ON” button at intervals
of 1 second, as many times as the hours of delay of departure.
On completion of the sequence, wait for the robot to conrm the delay setting with the sound of a beep.
The robot will be in standby until the working cycle resumes the established time.
Important
In case of errors, turn off the robot by keeping the “ON/OFF” button pressed, and resume the start-up sequence.