User`s manual

- 53 -
C141501700.fm
User's manual
GB
On the display "Off
Perimeter" appe-
ars
Excessive ground slope.
Mark the area with excessive
gradient (see "Equipment in-
stallation planning").
Install the Kit for working on
slopes greater than 27° (see
"Specifications").
Perimeter cable incor-
rectly placed
Check that the wire is instal-
led properly (too deep, close
to metal objects, distance
between the wire that marks
two elements less than 70
cm, etc.) (see "Equipment in-
stallation planning")
Perimeter wire marking
inside areas (beds, bu-
shes, etc.) placed
clockwise.
Relocate the perimeter wire
correctly (anticlockwise direc-
tion) (see "Perimeter wire in-
stallation")
Overheated power supply
unit
Adopt suitable solutions to re-
duce the temperature of the
power supply unit (air or chan-
ge the installation area, etc.)
(see "Equipment installation
planning")
The wheel drive is not
correct
Check and, if necessary, cor-
rectly fasten the wheels.
On the display
"Blackout" appe-
ars.
Power supply break to
the transmitter
Restart the robot
Overheated power supply
unit
Adopt suitable solutions to re-
duce the temperature of the
power supply unit (air or chan-
ge the installation area, etc.)
(see "Equipment installation
planning")
Presence of other near-
by installations
Contact an Assistance Cen-
tre authorized by the Manu-
facturer
On the display
"Wheel motor er-
ror" appears
Rough ground or with ob-
stacles that hinder move-
ment
Check that the lawn to trim is
even, and without pits, stones
or other obstacles. If so, per-
form the necessary clearan-
ce operations (see
"Preparation and delimitation
of work areas (main and se-
condary)")
One or both motors, star-
ting the wheel transmis-
sion, in breakdown
Get the motor repaired or re-
placed by the nearest authori-
zed Assistance centre.
On the display
"Bump Error" ap-
pears
The shock sensors are
blocked
Remove the hood and check
that the sensors are functio-
ning.
Problem Causes Solutions