User`s manual

- 52 -
C141501700.fm
User's manual
GB
The working area
is not completely
trimmed
Insufficient work hours
Extend the work timetable
(see "Programming mode")
Cutting blade with deposi-
ts and/or residues
Stop the robot in safety condi-
tions (see "Robot safety stop")
Caution
Use protection gloves to
avoid the risk of cuts on
hands.
Clean the cutting blade
Cutting blade worn out
Replace the blade with an ori-
ginal spare part (see "Replace
the blade")
Working area too big
compared to the actual
capacity of the robot.
Ad just the working area (see
"Specifications")
Batteries are about to
deplete their life cycle.
Replace the batteries with ori-
ginal spare part (see "Batte-
ries replacement")
The batteries do not re-
charge completely.
Clean and eliminate any oxida-
tion from the batteries con-
tact points (see "Robot
cleaning").
Recharge the batteries for at
least 12 hours.
Secondary area
not completely
mown
Wrong programming
Correctly programme the se-
condary area (see "Program-
ming mode")
On the display "No
Signal" appears.
The perimeter wire is not
correctly connected (bro-
ken wire, lack of electric
connection, etc.).
Check the functionality of the
electricity supply, correct con-
nection of the transmitter-
power supply group and that
of the recharging station (see
"Installation of recharging sta-
tion and transmitter-power
supplier group")
Problem Causes Solutions