User`s manual

- 48 -
C141501700.fm
User's manual
GB
Here below are some indications to fol-
low during the use of the robot.
– Even after a proper reading of instruc-
tions, at its first use, simulate some
test moves to detect the controls and
the main functions.
– Check that the nuts and bolts secur-
ing all main parts are tight.
– Carry out a frequent trimming of the
lawn to avoid an excessive growing of
the grass.
– Do not use the robot to trim grass
higher than 10 cm.
– If the lawn is equipped with an auto-
matic irrigation system, programme
the robot so that it re-enters the re-
charging station at least 1 hour be-
fore the start of irrigation.
– Check the ground gradient and make
sure that it does not exceed the maxi-
mum values allowed so that the use of
the robot does not cause dangers.
– The lawn mower should be pro-
grammed in order to prevent it from
working more than necessary; always
consider the different growth of the
grass according to the season in or-
der to avoid a useless wear of the
lawn mower and a decrease in the
battery life.
Important
During maintenance operations, use
the individual protections indicated by
the Manufacturer, especially when in-
tervening on the blade.
Before performing maintenance opera-
tions, make sure that the robot has
stopped in safety conditions (see "Ro-
bot safety stop").
OPERATING REMINDERS
ORDINARY MAINTENANCE
MAINTENANCE REMINDERS
PROGRAMMED MAINTENANCE INTERVALS CHART
Frequency Component Type of operation Reference
Every week
Blade
Clean and check the
efficiency of the blade
See "Robot
cleaning"
If the blade is bent due
to an impact or if it is
worn-out, replace it.
See "Replace the
blade"
Battery recharge
knobs
Clean and remove any
oxidations
See "Robot
cleaning"
Contact plates
Clean and remove any
oxidations
See "Robot
cleaning"
Every month Robot Carry out cleaning
See "Robot
cleaning"