User`s manual

- 35 -
C141501700.fm
User's manual
GB
the robot immediately after rapid re-
entry setting.
4-Press the "+" Key
and the "-" Key to
enter the number
of work cycles to
perform in the
main area, the lawn mower starts
then to machine the first secondary
area.
Important
If secondary areas are provided (type 1
or 2), to complete the field of functions
relative to the number of cycles and
time it is necessary to insert the value
0.
5-Press the key "En-
ter" to confirm.
On the display "SEC-
ONDARY AREA 1 -
Time" appears.
6-Press one of the
keys "+", "-" to in-
sert the time (in
minutes) meas-
ured to reach the
secondary area.
7-Press the key "En-
ter" to confirm.
The cursor
moves on to the
next position.
8-Press one of the
keys "+", "-" to in-
sert the time (in
seconds).
9-Press the key to
confirm.
Important
If secondary areas are provided (type 1
or 2), to complete the field of functions
relative to the number of cycles and time
it is necessary to insert the value 0.
On completion of the
procedure, on the
display the " SEC-
ONDARY AREA 2 -
No. Cycles" function appears.
SECONDARY AREA 2: function to de-
fine automatic mowing of a secondary
area 2.
1-To set the number of cycles and time
of the secondary area 2, repeat the
same procedure indicated for "SEC-
ONDARY AREA 1".
Important
If secondary areas are provided (type 1
or 2), to complete the field of functions
relative to the number of cycles and time
it is necessary to insert the value 0.
On completion of the
procedure, on the
display the "PERIME-
TER" function ap-
pears.
PERIMETER: function for setting the
robot with the impact or perimeter
wire recognition modality.
1-Press one of the keys "+", "-" to set
the type of delimitation installed
along the perimeter.
Select YES if the perimeter wire is in-
stalled.
Select NO if the perimeter wire is not in-
stalled.
Select ×2 in case of signal problems (pe-
rimeter wire installed).