User`s manual

- 3 -
C141501700.fm
User's manual
GB
GENERAL INFORMATION .............................. 4
TECHNICAL INFORMATION .......................... 5
SAFETY INFORMATION .................................. 9
INSTALLATION ................................................ 11
ADJUSTMENTS .............................................. 27
USE AND FUNCTIONING ............................ 29
ORDINARY MAINTENANCE ...................... 48
FAILURES, CAUSES AND SOLUTIONS .. 50
PARTS REPLACEMENTS ............................ 55
CONTENTS
A
Adjusting the cutting height,
28
Adjustment reminders, 27
Automatic cycle start, 38
B
Batteries replacement,
56
Battery installation and connection, 23
Blade installation, 23
D
Display visualisation in work phase,
42
E
Enter password,
42
Equipment general description, 5
Equipment installation planning, 12
I
Identification of manufacturer and appliance,
4
Installation of recharging station and
transmitter-power supplier group,
20
M
Maintenance reminders,
48
Manual startup and stop of robot (in closed areas), 40
O
Operating reminders,
48
P
Packaging and unpacking,
11
Parts replacement reminders, 55
Perimeter wire installation, 17
Preparation and delimitation of work
areas (main and secondary),
14
Programmed maintenance intervals chart, 48
Programming mode, 31
Prolonged inactivity and service restart, 42
Purpose of this manual, 4
R
Rain sensor adjustment,
29
Recharge batteries for extended inactivity, 44
Recharge batteries on first use, 27
Recommendations for use, 29
Remote control description, 31
Replace the blade, 61
Requesting technical assistance, 5
Robot automatic stop, 39
Robot cleaning, 49
Robot controls description, 30
Robot disposal, 62
Robot safety stop, 39
Robot start without perimeter wire, 41
S
Safety for man and the environment
during disposal,
10
Safety rules, 9
Safety signals, 11
Setting for rapid robot re-entry into the
recharging station,
19
Specifications, 7
T
Telecommand batteries replacement,
62
Troubleshooting, 50
ANALYTICAL CONTENTS
Reproduction, even partial, of this document without written permission by the ma nufacturer is forbidden. The manufacturer assumes a policy of continual improvement and reserves the right to modify this do-
cument without prior notice on condition that modifications do not const itute safety risks.
© 2002 - Text, illustrations and page setting by: IDM expe rts in technical communications - Forlì - Texts may be partially or totally reproduc ed if the author is cited.