Operation Manual

- 38 -
C141501600.fm
User's manual
GB
The working area
is not completely
trimmed
Cutting blade with depos-
its and/or residues
Clean the cutting blade
Cutting blade worn out
Replace the blade with an
original spare part.
Working area too big
compared to the actual
capacity of the robot.
Ad just the working area (see
"Specifications")
Batteries are about to
deplete their life cycle.
Replace the batteries with
original spare part.
The batteries do not re-
charge completely.
Recharge the batteries for at
least 12 hours
The robot stopped
with the led (F)
(red) and (H) (yel-
low) flashing.
Power supply break to
the transmitter
Restart the robot
Overheated power supply
unit
Adopt suitable solutions to re-
duce the temperature of the
power supply unit (air or change
the installation area, etc.).
The wheel drive is not
correct
Check and, if necessary, ad-
just the chain tensioning.
The robot stopped
with the led (F)
(red) flashing and
the led (G) (blue)
on. Blade motor
error
Damaged cutting blade
Replace the blade with an
original spare part.
Cutting blade flooded by
residues (tapes, ropes,
plastic fragments, etc.).
Remove the flood cause from
the blade.
Caution
Use protection gloves to
avoid the risk of cuts on han-
ds.
The start of the robot oc-
curred with obstacles be-
ing too close (less than m
away) or in presence of
unexpected obstacles
(fallen branches, forgot-
ten objects, etc.).
Stop the robot in safety condi-
tions (see "Robot safety
stop").
Remove the obstacles and re-
start the robot (see "Manual
start and stop of the robot")
Electrical motor malfunc-
tion
Get the motor repaired or re-
placed by the nearest author-
ized Assistance centre.
The robot stopped
with the leds (F)
(red ) and (G)
(blue) flashing.
Wheel motor er-
ror
The wheel drive is not
correct
Check and, if necessary, ad-
just the chain tensioning.
Rough ground or with ob-
stacles that hinder move-
ment.
Check that the lawn to trim is
even, and without pits, stones
or other obstacles. If so, per-
form the necessary clear-
ance operations.
One or both motors,
starting the wheel trans-
mission, in breakdown.
Get the motor repaired or re-
placed by the nearest author-
ized Assistance centre.
Problem Causes Solutions
E F
C
D
A
L
G H
BM