Operation Manual

- 35 -
C141501600.fm
User's manual
GB
1-Clean all the outside surfaces of the
robot with a sponge soaked in warm
water and neutral soap and rinse
properly.
2-Do not use solvents or benzine so not
to damage the varnished surfaces
and the plastic components.
3-Do not wash the inside parts of the
robot and do not use water jets in
pressure so not to damage the elec-
tric and the electronic components.
Warning - Caution
In order not to irreversibly damage the
electric and electronic components, do
not plunge the robot, partially or com-
pletely in water, as it is not watertight.
4-Check the lower part of the robot
(cutting blade area and wheels) and
remove the deposits and/or resi-
dues that might obstruct the correct
functioning of the robot.
To remove the deposits and/or oth-
er residues from the blade, use a
suitable brush.
Warning - Caution
Use protection gloves to avoid the risk
of cuts on hands.
5-Clean the battery recharge knobs
and remove any deposits due to elec-
tric contacts with a dry cloth and, if
necessary, with fine-grained abrasive
paper.
PROGRAMMED MAINTENANCE INTERVALS CHART
Frequency Component Type of intervention Reference
Every month Wheel drive
Check the chain
tension
see “Chain tension
adjustment”
Controllare la tensione
delle catene
Every week Blade
Clean and check the ef-
ficiency of the blade
see “Robot clean-
ing”
If the blade is bent due
to an impact or if it is
worn-out, replace it
see “Replace the
blade”
Every week
Battery recharge
knobs
Clean and remove any
oxidations
see “Robot cleaning”
Robot Carry out cleaning see “Robot cleaning”
ROBOT CLEANING