Operation Manual

- 29 -
C141501600.fm
User's manual
GB
Before lifting the robot to manually trans-
fer it in another working area, it is neces-
sary to stop it in safety conditions.
To stop the robot, it is enough to press
the "stop" (B) push button.
The robot and the blade stop almost in-
stantly.
Take the robot in the other working area
and start it (see "Manual start and stop
of the robot").
This functioning mode is used to make
the robot move with the stopped blade
(for example to cross connection areas
from one area to another (not to trim) at
least 70 cm wide).
Press the "start" (L) push button for an
extended time (over 3 seconds).
The robot stops and restarts after a
short while with the stopped blade.
After the robot has been guided with the
remote control in new area to trim,
press again the "start" (L) push button
for an extended time (over 3 seconds).
The robot stops and restarts after a
short while with the blade in motion to
trim the lawn of the new marked area.
Important
Remote control programming must be
carried out with the robot turned off.
1-Press the "start" (A) push button of
the robot and keep it pushed.
2-Press the "start" (L) push button of
the remote control and release it
when the robot releases an acoustic
signal and the leds (G-H) flash alter-
nately.
3-Release the "start" (A) push button.
4-Press in sequence the (M) push but-
ton, then the (L) push button and, fi-
nally, the (N) push button.
Important
Each time one of the push buttons (M-
L-N) is pressed, the robot releases an
acoustic signal and, finally, turns off.
Once programming is completed, re-
start the robot and try to use it with the
remote control to check its correct func-
tioning (see "Robot start without perime-
ter wire").
ROBOT MANUAL TRANSFER (FROM ONE AREA TO ANOTHER)
ROBOT TRANSFER BY REMOTE CONTROL (FROM ONE AREA TO ANOTHER)
REMOTE CONTROL PROGRAMMING PROCEDURE