User's Manual

Q206 User Manual
11
Battery installation
1，Slide the battery door up and then remove the door.
2，Aim the metal terminals of the battery at those in the battery compartment and then
push down and into it.
Battery charging:
New batteries are not fully charged. Open the protective cover on your phone’s
accessory connector port, then insert the battery charger plug into the accessory
connector port on the side of your phone as shown, and plug the other end into an
electrical outlet. Your phone might require several hours to charge fully. When your
phone is power off, it might take a few seconds to show charging display and it shows
charge complete when finished. When your phone is power on, the battery icon flickers
when it starting charging and become still with full bars in battery icon when finished.
3.3 Memory Card
You can use removable memory card with your phone to store information.
Caution: Don’t bend or scratch your memory card. Keep it away from static electricity,
water, and dirt.
Insert the memory card into the tray as shown below:
3.4 Turn it on/off
Caution: On power up, the phone may prompt you to enter your SIM card PIN code to
unlock the SIM card. If your phone shows Input PUK code that express your SIM card is
locked, please contact your web service provider.
To turn on your phone, press and hold the power on/off key for two seconds. If prompted,
enter your four-to-eight-digit SIM card PIN code and/or four-digit unlock code.
If you don’t insert a SIM card, your phone shows Insert SIM. None of the functions
related to SIM card can be used and you can make an emergency call only.
To turn off your phone, press and hold the power on/off key for two seconds.